NCMC Ottawa-Gatineau Mitsubishi club

Wiring Harness for trailer correct routing

Post new topic   Reply to topic

National Capital Mitsubishi Club :: Mitsubishi Models :: Outlander 2nd Generation (2007 and newer) :: Electronics / Electricals

View previous topic View next topic Go down

Wiring Harness for trailer correct routing

Post  Howdy on Sat May 23, 2009 9:01 pm

I have an 09 Outlander and dealer installed harness and left plug in the compartment where jack is stored.So when I need it I have to take it out of that compartment and feed it between my tailgate and bumper..not very user friendly and a hassle.
What it the proper way to route it it the back?
Thanks Suspect

Howdy

Posts: 5
Join date: 2009-03-28

View user profile

Back to top Go down

Re: Wiring Harness for trailer correct routing

Post  Roach on Sun May 24, 2009 12:57 am

Howdy wrote:I have an 09 Outlander and dealer installed harness and left plug in the compartment where jack is stored.So when I need it I have to take it out of that compartment and feed it between my tailgate and bumper..not very user friendly and a hassle.
What it the proper way to route it it the back?
Thanks Suspect


I have the OEM one on my 07 XLS and from what I can see it's routed somewhere in the rear fender to the outside down to the hitch It must have a hole some where with a plug !

_________________

Roach
Admin
Admin

Posts: 1140
Join date: 2007-09-28
Location: Gatineau, Quebec

View user profile http://www.mitsubishiottawa.ca http://ncmc.forumotion.com

Back to top Go down

Re: Wiring Harness for trailer correct routing

Post  Howdy on Sun May 24, 2009 9:34 pm

Thanks I shall have a look in that area.

Howdy

Posts: 5
Join date: 2009-03-28

View user profile

Back to top Go down

View previous topic View next topic Back to top

Post new topic   Reply to topic

National Capital Mitsubishi Club :: Mitsubishi Models :: Outlander 2nd Generation (2007 and newer) :: Electronics / Electricals

Permissions of this forum:
You cannot reply to topics in this forum